模块标题

当前位置:首页 > 新闻中心

业务种类

IP2防水micro母座AB型 180度立插 /1.5长针

作者:深圳富盈科技有限公司
  STANDARD   ATMOSPHEIC   CONDITIONS   测试标准状度   UNLESS OTHERWISE SPECIFIED   THE STANDARD RANGE OF ATMOSPHERIC   CONDITIONS FOR MAKING MEASUREMENTS   AND TESTS ARE AS FOLLOWS:   () BETWEEN BODY AND CONDUCTOR: oC TO ℃   () BETWEEN CONDUCTORS NOT TO BE CONTACT:% TO %   () PRESSURE:Kpa TO Kpa   在没有指定的情况下测试温度、湿度、气压如下:   ()温度为℃~℃   ()湿度为%~%   ()气压为 Kpa~Kpa   MECHANICAL(机械性能)   ITEM项目   TEST CONDITIONS测试条件   PERFORMANCE 规格      CONNECTION   FORCE   插入力度   MEASUREMENT SHALL BE MADE AFTER CONNECTING AND DISCONNECTING USING STANDARD PLUG GAUGE TIMES。   依据标准的PLUG GAUGE做第次拔插后测定   ~N   DISCONNECTION   FORCE   拔出力度   MEASUREMENT SHALL BE MADE AFTER CONNECTING AND DISCONNECTING USING STANDARD PLUG GAUGE TIMES。   依据标准的PLUG GAUGE做第次拔插后测定   ~N      TERMINAL   STRENGTH   端子强度   A STATIC LOAD OF .N/m(kgf/cm)SHALL BE APPLIED TO THE TIP OF THE TERMINAL FOR MIN   IN ANY DIRECTION   向排脚先端的任意个方向加分钟.N/m(kgf/cm)的力度.   THERE SHALL BE NO DAMAGE   TO THE TERMINAL SUCH AS CRACKS, LOOSENESS OR PLAY ELECTRICAL ,AND MECHANICAL   CHARACTERISTICS SHALL BE SATISFIED   在排脚中没有裂开、松动等异常,满足于机械、电气性能   ELECTRICAL(电气性能)   ITEM项目   TEST CONDITIONS测试条件   PERFORMANCE规格   .   CONTACT   RESISTANCE   接触电阻   MEASURED AT SMALL CURRENT(m A OR LESS)   Hz   在微小电流( m A)以下测试   .ω   .   INSULATION RESISTANCE   绝缘电阻   APPLY A VOLTAGE OF V DC FOR MIN   TO FOLLOWING PORTIONS AFTER WHICH MEASUREMENT   SHALL BE MADE:   () BETWEEN BODY AND CONDUCTOR   () BETWEEN CONDUCTORS NOT TO BE CONTACT   () BETWEEN CONDUCTORS NOT TO BE WHEN PLUG IS INSERTED DC V MIN   输入V DC电压分钟,按以下接触方法测试:   () 插座体与排脚之间   () 不接触的排脚之间   () 插头插入时不接触排脚之间   Mω
深圳富盈科技有限公司

1509784134369341.jpg


官网地址: http://www.fyxykj.com 

电话:15813829585

地址:深圳市宝安区松岗街道大洋洲工业区